MPI-R10

Features and applications

MPI-R10 measuring system connected to a specific sensor FC-MPI, combined with the magnetic band M-BAND-10, is a complete system for the measurement of linear and angular displacement (with a minimum radius of 65 mm).

Characterised by an extremely easy assembly, it allows precise alignment and positioning, reducing time and machining procedures to the minimum.

• Maximum ease of assembly and disassembly operations of the device from the panel, thanks to a system with retention wing (ELESA PATENT).

• 7-digit LCD of 12 mm height and special characters.

• Programmable with 4 multifunction keys.

• Values displayed in millimeters, inches or angular degrees.

• Display of absolute or incremental mode.

• Up to 10 programmable offset values.

• Storage and display of 32 target positions.

• Long-life internal lithium battery.

• Buffered memory during battery substitution.

• Housing for FC-MPI connector with snap-in assembly system for easy insertion and removal.

For further information read the operating instructions.

 

(1) Reading speed affects battery life.

(2) Resolution: the smallest variation in length that the system is able to display.

(3) Accuracy: the maximum deviation of the value measured by the system with respect to the real value.

(4) Repeatability: the degree of closeness between a measurement series of the same sample, when the individual measurements are made, leaving the measurement conditions unchanged.

Magnetic sensor with cable

FC-MPI to be ordered separately.

Accessories on request

Magnetic band M-BAND-10.

Special executions on request

The display of special plate may be supplied with customised graphic symbols, marks or writings.

Assembly instructions

• Drill the sheet (thickness 0.7÷2 mm) according to the template dimensions.

• Remove all drilling burrs before fitting the case.

• Fit the lower part of the case into the housing and press until the complete snap fitting (Fig.1).

 

 

Battery replacement instructions

• Remove the indicator from its seat, applying pressure to the retention wing bringing it to the stop with the aid of a slotted screwdriver (Fig.2).

• Unscrew the AISI 304 stainless steel self-tapping screw with six-lobe socket for TORX^®* T06 tool and remove the closing plate (Fig.3).

• Replace the battery paying attention not to invert the polarity (see the position indicated on the cover).

• The replacement of the battery if carried out within 10 seconds (duration of the buffer power supply) avoids the loss of the configuration parameters.

 

 

_{* Registered trademark by TEXTRON INC.}